How to set up the manual white balance of the Sony Chip Camera - LowerHeli.com

Categories

Categories

Additional Information

Additional Information

Account Navigation

Account Navigation

Currency - All prices are in AUD

Currency - All prices are in AUD
 Loading... Please wait...
LowerHeli.com
                            FREE SHIPPING Over $50

Categories

Categories

How to set up the manual white balance of the Sony Chip Camera

Posted by on

This tip allows you to fly into the sun without getting the picture wiped out.

How to set up the manual white balance of PZ0420, CMQ1993X and PZ0420H?                           


  1. 1. Enter OSD interface and then select RESET (Figure 1)--FACTORY RESET (Figure 2):

  2. 2. With enough light, set up the camera towards a scene of white or grey paper. Enter the SETUP interface, select WHITE BAL. MANUAL (Figure 3) and adjust RED and BLUE until the color is consistent or similar to that you see with eyes (Figure 4):

  3. 3. Go back to SETUP Menu, select WHITE BAL. MANUAL and change to WHITE BAL.ATW1 (Figure 5-6), to make sure there will not be too much difference in color temperature. If color changes dramatically from MANUAL to ATW1, please go back to Step 2. If the color is suitable for you, please set as WHITEBAL.MANUAL, save and exit:

  4. 4. Figure 7 and Figure 8 is an indoor color comparison between manual white balance and auto white balance. Set as manual white balance, color temperature deviation caused by light entering the Sensor in different angles can be reduced effectively: